# Avid CNC's SpindleWarmup routine **URL:** \ **Category:** General Chat\ **Created:** [February 12, 2023, 2:54am UTC](https://forum.avidcnc.com/t/avid-cncs-spindlewarmup-routine/1715 "2023-02-12T02:54:19Z")\ **Posts on this page:** 1\ **Showing post:** 12
**Author:** ![subnoize](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/subnoize/32/2197_2.png) [@subnoize](https://forum.avidcnc.com/u/subnoize)\ **Post date:** [February 12, 2023, 9:17pm UTC](https://forum.avidcnc.com/t/avid-cncs-spindlewarmup-routine/1715/12 "2023-02-12T21:17:53Z")
> [@corbin](#): > > ug…that sounds scary! I have broken a lot of very expensive equipment so yes, very scary. Mach4 is not on the same level as LinuxCNC or other commercial motion planners. > [@corbin](#): > > Have you shared your M6 code? I am hoping April will be the big month. To be fair to AvidCNC and to respect their forum, my progress is covered under build logs. It is looking like the dust manifold will be first and will be independent of the tool carousel. So if you want static posts it will be a minor install. I think I might even make it a state machine for those who don’t mind losing the top 12 inches off the work envelop. The last foot will trigger the dust manifold to open so you can do a tool change. > [@SUBNOIZE: 10 Tool Carousel, Tool Length Sensor and Dust Manifold](https://forum.avidcnc.com/t/subnoize-10-tool-carousel-tool-length-sensor-and-dust-manifold/1096/38): > > Ah! The thread was so long I had forgotten that. Yeah, that’s what my manifold did. Eight nozzles for each ring, one ring facing in, and one facing down. I look forward to trying it slight_smile --- _[View the full topic](https://forum.avidcnc.com/t/avid-cncs-spindlewarmup-routine/1715)._