# Casters for Pro w/factory base
**URL:** https://forum.avidcnc.com/t/casters-for-pro-w-factory-base/6062
**Category:** General Chat
**Created:** [April 24, 2026, 12:13am UTC](https://forum.avidcnc.com/t/casters-for-pro-w-factory-base/6062 "2026-04-24T00:13:10Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@SSBN\_RO](https://forum.avidcnc.com/u/SSBN_RO)
#### Post date: [April 24, 2026, 12:13am UTC](https://forum.avidcnc.com/t/casters-for-pro-w-factory-base/6062/1 "2026-04-24T00:13:10Z")
When you can’t avoid moving your machine… available on Amazon
---
### Author:  [@CosaMia](https://forum.avidcnc.com/u/CosaMia)
#### Post date: [April 29, 2026, 11:46am UTC](https://forum.avidcnc.com/t/casters-for-pro-w-factory-base/6062/2 "2026-04-29T11:46:53Z")
How well, did this work for you? I have a 5x10, that I need to rotate. I was thinking of making some furniture sliders out of some scrap ply and UHMW to just get the thing rotated 180 degrees, but what you did might work better.
---
### Author:  [@SSBN\_RO](https://forum.avidcnc.com/u/SSBN_RO)
#### Post date: [April 29, 2026, 12:20pm UTC](https://forum.avidcnc.com/t/casters-for-pro-w-factory-base/6062/3 "2026-04-29T12:20:16Z")
The only drawback was that the leveling feet had to be fully retracted.
---
### Author:  [@Cameron](https://forum.avidcnc.com/u/Cameron)
#### Post date: [April 29, 2026, 12:35pm UTC](https://forum.avidcnc.com/t/casters-for-pro-w-factory-base/6062/4 "2026-04-29T12:35:31Z")
They may need to be reset anyway in the new location. This is a much better way than I was thinking! I’d decided not to move it and work around the placement to avoid rebuilding it, but now…