# Cowhide Laser engraving **URL:** \ **Category:** Everything Lasers\ **Created:** [July 14, 2026, 8:04pm UTC](https://forum.avidcnc.com/t/cowhide-laser-engraving/6355 "2026-07-14T20:04:54Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![Eric](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/eric/32/3220_2.png) [@Eric](https://forum.avidcnc.com/u/Eric)\ **Post date:** [July 14, 2026, 8:50pm UTC](https://forum.avidcnc.com/t/cowhide-laser-engraving/6355/2 "2026-07-14T20:50:42Z")
Did you try any of the speeds here? > [@Laser Feed and Speed Chart](https://forum.avidcnc.com/t/laser-feed-and-speed-chart/5374): > > Hey folks! I’ve had several people ask about getting some suggested feeds and speeds for the Avid laser system. Opt has published a lot of information and we have done a lot of testing too. I’ve taken all of that information and I’ve put it on this sheet here: A lot of the feedrates I found were WAY to fast to practically run on most routers, so what I did was scale down the power and speed. For example if an engraving speed was 100% power at 800 IPM I scaled it down to 200IPM at 25% power. I… --- _[View the full topic](https://forum.avidcnc.com/t/cowhide-laser-engraving/6355)._