# Homing axes Y problem **URL:** \ **Category:** General Chat\ **Tags:** mach4\ **Created:** [September 18, 2025, 3:51pm UTC](https://forum.avidcnc.com/t/homing-axes-y-problem/5267 "2025-09-18T15:51:36Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![Ernest](https://avatars.discourse-cdn.com/v4/letter/e/c67d28/32.png) [@Ernest](https://forum.avidcnc.com/u/Ernest)\ **Post date:** [September 18, 2025, 3:51pm UTC](https://forum.avidcnc.com/t/homing-axes-y-problem/5267/1 "2025-09-18T15:51:37Z")
Hi guys greetings from Spain, because I am so far away and I like Avid machines so much I made an exact copy of the Avid Pro 4896, it is already finished but I have a problem when doing homing everything works ok, but in the Y and YA axes one of the sides stops with the sensor the other side does not, and it makes the gantry force itself, I know it is a configuration issue but I am new to these issues and I do not dare much, if you could help me I would appreciate it with a screenshot etc. I have Mach 4 and EESS, thanks from Spain. ---
**Author:** ![Eric](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/eric/32/3220_2.png) [@Eric](https://forum.avidcnc.com/u/Eric)\ **Post date:** [September 19, 2025, 7:36pm UTC](https://forum.avidcnc.com/t/homing-axes-y-problem/5267/3 "2025-09-19T19:36:26Z")
You’re going to have a bit of a hard time with getting support on a cloned machine.. Are you running our control box or is this a totally homegrown solution? If the latter you might want to check out the MachSupport forums. ---
**Author:** ![Ernest](https://avatars.discourse-cdn.com/v4/letter/e/c67d28/32.png) [@Ernest](https://forum.avidcnc.com/u/Ernest)\ **Post date:** [September 19, 2025, 8:25pm UTC](https://forum.avidcnc.com/t/homing-axes-y-problem/5267/4 "2025-09-19T20:25:11Z")
Thanks Eric, it’s my homemade electronics, but it has practically the same components. I’m waiting for them to admit me to the bull to ask too.