# New and fun problem

**URL:** <https://forum.avidcnc.com/t/new-and-fun-problem/1498>\
**Category:** General Chat\
**Created:** [December 29, 2022, 10:33pm UTC](https://forum.avidcnc.com/t/new-and-fun-problem/1498 "2022-12-29T22:33:40Z")\
**Posts on this page:** 2\
**Page:** 2

<div class="post-metadata">

**Author:** ![MichaelDot](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/michaeldot/32/520_2.png) [@MichaelDot](https://forum.avidcnc.com/u/MichaelDot)\
**Post date:** [January 28, 2023, 3:28pm UTC](https://forum.avidcnc.com/t/new-and-fun-problem/1498/21 "2023-01-28T15:28:13Z")

</div>

Thanks for the reply. I did figure that out after disconnecting the wires. I am used to this sort of behavior on printers and smaller projects. I just figured that with the cost of the controller, it would have a way of filtering that. I was wrong and should have tested that the second I tried it at first.

---

<div class="post-metadata">

**Author:** ![Erik](https://avatars.discourse-cdn.com/v4/letter/e/b5ac83/32.png) [@Erik](https://forum.avidcnc.com/u/Erik)\
**Post date:** [January 28, 2023, 3:59pm UTC](https://forum.avidcnc.com/t/new-and-fun-problem/1498/22 "2023-01-28T15:59:18Z")

</div>

Glad you figured it out.

[Previous page](https://forum.avidcnc.com/t/new-and-fun-problem/1498.md?page=1)