# Spindle overloads and drags 200 lb epoxy table 5 inches before I could stop it **URL:** \ **Category:** General Chat\ **Created:** [December 14, 2025, 9:44pm UTC](https://forum.avidcnc.com/t/spindle-overloads-and-drags-200-lb-epoxy-table-5-inches-before-i-could-stop-it/5566 "2025-12-14T21:44:05Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![Eric](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/eric/32/3220_2.png) [@Eric](https://forum.avidcnc.com/u/Eric)\ **Post date:** [December 15, 2025, 2:37pm UTC](https://forum.avidcnc.com/t/spindle-overloads-and-drags-200-lb-epoxy-table-5-inches-before-i-could-stop-it/5566/4 "2025-12-15T14:37:53Z")
Did you have the spindle fault enabled or disabled? If you had it enabled you would have had to do this to your VFD: [VFD Parameter Changes - EX Controller Technical Manual](https://www.avidcnc.com/support/instructions/electronics/ex/manual/ex_vfd_update/) There are dip switches or jumpers on your servo connector board in the control box that allow you to select if you want VFD faults to halt the system… > **[Servo Boards with DIP Switches - System Settings - EX Controller Technical...](https://www.avidcnc.com/support/instructions/electronics/ex/manual/servo/24.1/systemSettings/#servo-boards-with-dip-switches)** This only works if you VFD has been programmed with the above link. --- _[View the full topic](https://forum.avidcnc.com/t/spindle-overloads-and-drags-200-lb-epoxy-table-5-inches-before-i-could-stop-it/5566)._