# Vacuum Hold Down

**URL:** <https://forum.avidcnc.com/t/vacuum-hold-down/6737>\
**Category:** General Chat\
**Created:** [November 8, 2026, 4:38am UTC](https://forum.avidcnc.com/t/vacuum-hold-down/6737 "2026-11-08T04:38:48Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![jjneeb](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/jjneeb/32/244_2.png) [@jjneeb](https://forum.avidcnc.com/u/jjneeb)\
**Post date:** [November 8, 2026, 4:38am UTC](https://forum.avidcnc.com/t/vacuum-hold-down/6737/1 "2026-11-08T04:38:48Z")

</div>

I have been playing around with some configurable vacuum hold downs for my CNC bed. I wanted something to replace two sided tape when doing multiple parts.

[![](https://canada1.discourse-cdn.com/flex027/uploads/avidcnc/original/2X/2/24713001311973352b826918edb0d1d1f182c436.jpeg "Custom CNC Vacuum Pads to use with Vacudogs for an Adjustable Vacuum Clamping Hold Down System.") ](https://www.youtube.com/watch?v=jmVjktfsNSs)

---

<div class="post-metadata">

**Author:** ![lucasdavis](https://avatars.discourse-cdn.com/v4/letter/l/e99b99/32.png) [@lucasdavis](https://forum.avidcnc.com/u/lucasdavis)\
**Post date:** [November 13, 2026, 6:15pm UTC](https://forum.avidcnc.com/t/vacuum-hold-down/6737/2 "2026-11-13T18:15:30Z")

</div>

If you’re cutting multiple small parts, a full-sheet vacuum setup can be leaky; gasketed pods or a bleeder board with dedicated zones may hold better. Size the pump for leakage, and keep tabs on very small pieces where the vacuum area is limited.
