# Vertical work holding

**URL:** <https://forum.avidcnc.com/t/vertical-work-holding/1893>\
**Category:** General Chat\
**Created:** [March 25, 2023, 8:03pm UTC](https://forum.avidcnc.com/t/vertical-work-holding/1893 "2023-03-25T20:03:45Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![JeffsDesign](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/jeffsdesign/32/5574_2.png) [@JeffsDesign](https://forum.avidcnc.com/u/JeffsDesign)\
**Post date:** [March 25, 2023, 8:03pm UTC](https://forum.avidcnc.com/t/vertical-work-holding/1893/1 "2023-03-25T20:03:45Z")

</div>

In a month or so I plan on ordering the parts needed. I’m going to get the parts from 80/20. Because I can save a bit in shipping. They offer three styles ultra lite, lite, standard. Would there be problems with using ultra lite in the setup? Such as flexing. I’m thinking there wouldn’t be Because the way you’re cutting

---

<div class="post-metadata">

**Author:** ![corbin](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/corbin/32/2800_2.png) [@corbin](https://forum.avidcnc.com/u/corbin)\
**Post date:** [March 26, 2023, 2:54am UTC](https://forum.avidcnc.com/t/vertical-work-holding/1893/2 "2023-03-26T02:54:18Z")

</div>

Hi Jeff - Heavier is always better for absorbing vibrations. I’d go with the one that weighs the most, or make it out of steel.

---

<div class="post-metadata">

**Author:** ![JeffsDesign](https://yyz1.discourse-cdn.com/flex027/user_avatar/forum.avidcnc.com/jeffsdesign/32/5574_2.png) [@JeffsDesign](https://forum.avidcnc.com/u/JeffsDesign)\
**Post date:** [March 26, 2023, 10:35am UTC](https://forum.avidcnc.com/t/vertical-work-holding/1893/3 "2023-03-26T10:35:08Z")

</div>

Hi Corbin, Yes there is the vibrations too!

---

<div class="post-metadata">

**Author:** ![DavidsPostProcessor](https://avatars.discourse-cdn.com/v4/letter/d/76d3ee/32.png) [@DavidsPostProcessor](https://forum.avidcnc.com/u/DavidsPostProcessor)\
**Post date:** [March 26, 2023, 6:23pm UTC](https://forum.avidcnc.com/t/vertical-work-holding/1893/4 "2023-03-26T18:23:48Z")

</div>

I believe the leg parts are ‘ultralite’. You can always add weight/mass yourself without paying for it in aluminum and shipping charges up front.