Im trying to run a job, it stops the job and tell me to set up probe, i set up probe in utility but it gives no option to tell cnc12 where the probe is located. Fine, go back into cnc 12, try to zero with my plate, it gives me an error saying “you cannot use touchplate utility with an unmeasured too…

Ex controler problem number 5 thousand 54 probe

Eric Split this topic January 30, 2025, 11:38pm 6

A post was split to a new topic: Tool change step by step?

Topic		Replies	Views
Centroid KP-1 Touch Probe ex-controller	31	188	January 10, 2026
Problem with XYZ Probing EX Controller	31	222	February 24, 2025
Automatic Tool Height Setup Question	29	1430	November 4, 2022
Which probe to buy for Ex/ATC? touch-probe	24	523	May 19, 2025
Mach3 touch probe	7	1462	March 19, 2023