Feed smoothing control in new Mach4?

I just updated to the new Mach4 v2.5.12 and it seems to have defaulted to incorporating a very aggressive feed smoothing command in the corners that creates an unsettling table vibration.
I’m not finding the info I need on their site to address this.
Anyone experienced this phenomenon?

Did you get in touch with Support about this? If not I’d encourage you to do so.

Avid or Mach support?

Avid Support, you can get in touch here:

https://www.avidcnc.com/support/

I submitted a support request this afternoon.
Thanks Eric!

1 Like