Screen shot of the ports and pins for sensors

Hello Everyone, Would someone please be able to share a screen shot of all the ports and pins for a machine running on Mach3. I purchased a pro 48x48 years ago from an individual who mapped his ports and pins to work with a defective Sensor board. The connection for the X- was sheared off. Avid had him remap the X- to the A- as a work around till the new board was delivered. I purchased the machine like 5 years ago with the work around even though the board was received. I am wanting to install the new board and want to make sure that I have the ports and pins correct with out having to load the software once again. If you are able to proved the screen shots for the ports and pin for the sensors it would be appreciated. I have used the machine like this for the last 5 years with no issues but would like to get it fixed back to original. Thank you.

Electronics documentation here: Schematics - CNC Controller Technical Manual

Thank you for the information. This is very helpful.