ATC Hardware Setup for EX Controllers using CNC Depot Spindles (etc)

Hi everyone!

I wrote a guide on how I setup my EX Controller to use my HITECO ATC Spindle. This will work well for any ATC Spindle, such as the CNC Depot ones.

Avid CNC doesn’t officially support ATC spindles at this time, but I’m hoping this will help some people figure out how to wire their setup. This guide was based off what Eric started, so a big thanks to @Eric for getting it going!!

https://www.corbinstreehouse.com/blog/centroid-acorn-atc-hardware-setup-for-the-avid-cnc-ex-controller/

Once you get the hardware setup you can utilize my software program for setting up your ATC tool rack:

https://www.corbinstreehouse.com/blog/atc-automatic-tool-changer-for-centroid-cnc12/

Corbin

1 Like

Corbin: you rock!

1 Like

Thank you.

1 Like