I’m curious if it’s theoretically possible to run the Hiteco 4hp spindle at speeds slower than 6k. My understanding is that 6k is the slowest rpm that maintains enough torque to cut anything. Would it be possible to run at slower rpm if you don’t need the torque? I’d like to try using a manual edge…

There’s a configuration setting in Mach4 that you’ll need to change too - I’m away from home at the moment so can’t tell you where exactly. You can change it directly in the machine.ini file too (backup before messing with that one!) If the default for that spindle is 6000rpm, you could just try se…

The recommended minimum RPM for the spindle is based on two factors: available torque and adequate cooling. If you don’t need the torque and don’t expect running it for extended periods of time then the risk of a lower RPM is probably low. Don’t expect much torque below 1K.

Hiteco 4hp - Slower than 6k?

Stephen February 29, 2024, 4:32pm 2

@Bernmc has VFD parameters in another thread for reducing the slowest rpm. Dunno if that’s enough info.

1 Like

Topic		Replies	Views
How to set Spindle RPM to 1 within avid's Mach4?	4	180	July 16, 2024
What is the lowest safest rpm for 3hp spindle?	4	204	May 1, 2025
How to decrease the spindle speed to 2000 RPM for drilling application mach4	9	320	December 6, 2024
Do spindles have power band?	10	269	April 11, 2023
AV70S minimum rpm	7	156	December 27, 2025

Hiteco 4hp - Slower than 6k?

Related topics